Indian Journal of Science and Technology

Open Access Open Access  Restricted Access Subscription Access

Investigation on the Ignition Over Pressure Related to Launch Vehicle Lift-off


Affiliations
1 Satish Dhawan Space Centre, Sriharikota-524124, India
2 Sri Venkateswara Univeristy, Tirupathi, India
3 Department of Mechanical Engineering, IIT Madras, India
 

Several transient events occur during the startup of the Solid Rocket Motor (SRM) during the launch vehicle lift-off. Each event produces a complex transient signal and requires systematic assessment. The event discussed in this paper is Ignition Over Pressure (IOP). This Ignition Over Pressure is resulting from fluid dynamic compression of the accelerating plume gas, subsequent rarefaction and propagation during the pressure rise rate period in the rocket combustion chamber. These high-amplitude unsteady fluid-dynamic perturbations can adversely affect the vehicle and its surrounding structure. This wave behaves as a blast or shock wave characterized by a positive triangular shaped first pulse and negative half sine wave second pulse. The pulse travels upwards towards the propulsion system and has the potential to overload the individual elements or exciting overall vehicle dynamics. The later effect results from the phase difference of the wave from one side of the vehicle to the other due to the skew in the ignition of the strap-on boosters. In the case of the launchers, the mechanical stress due to the ignition over pressure wave comes, in addition to the acoustic constraint due to the jet noise. The over pressure phasing or ΔP environment, because of its spectral content as well as amplitudes becomes a crucial input for the design of sub-assemblies viz., thermal shields, and pay loads etc. In this paper, an attempt is made to numerically visualize the propagation of the blast wave causing the unsteady pressure oscillations during the transient pressure rise in the combustion chamber. To understand further, pressure measurements have been made at different heights along the umbilical tower during the solid rocket motor lift-off with the presence of jet deflectors, in order to capture the shock propagation phenomena. From the results, it appears that a sudden shock front that is generated during flow development within the rocket nozzle leaves a clear signature in the form of a well defined peak at typical time intervals. This overpressure amplitude seems to be related to the slope of the combustion chamber pressure rise rate during the transient period. It is also observed that the shock front initially propagates at supersonic speed but decays with time later. Similarly, the magnitude of the IOP peaks are also seen to decay with distance.

Keywords

Ignition Over Pressure, Shock Wave Propagation, Ignition Transient, Solid Rocket Motor, Numerical Flow Visualization
User

  • Broadwell JE, Tsu CN. Transient pressures caused by rocket start and shutdown in ducted launchers. J Spacecraft Rockets. 1967; 4(10):1323–1328.

  • Dougherty NS, Nesman TE, Guest SH. Shuttle SRB ignition over pressure: model suppression test program and flight results. JANNAF 13th Plume Technology Meeting. Houston, Texas, USA: CPIA Publication; 1982. p. 217–243.

  • Lai S, Laspesa FS. Ignition over pressure measured on STS lift-off and correlation with subscale model tests. JANNAF 13th Plume Technology Meeting. Houston, Texas, USA: CPIA Publication; 1982. p. 207–216.

  • Canabal F, Frendi A. A computational study of the ignition over pressure for launch vehicles. 8th AIAA/CEAS Aeroacou-stic Conference and Exhibit. Brekenridge, Colorado, USA; 2002. Report No: AIAA 2002–2541.

  • Canabal F, Frendi A. Suppression of ignition over pressure generated by launch vehicles. 10th AIAA/CEAS Aeroacoustic Conference. Manchester, United Kingdom; 2004. Report No: AIAA 2004–2833.

  • Varnier J. Blast wave at ignition of the rocket engines. ISMA 2002, Louvain (Belgique), TP 2002–175; Ce document comporte 9 pages, Ce Tiré à part fait référence au Document d’Accompagnement de Publication DSNA0224, Onde de souffle à l’allumage des propulseurs par; 2002.

  • Varnier J. Experimental study of the blast wave at ignition of rocket engines. 6th International Symposium on Launchers Technologies, MUNICH; 2005. ALLEMAGNE Ce Tiré à part fait référence au Document d’Accompagnement de Publication DSNA0543.

  • Marshall FL. Prediction of inlet duct overpressures resulting from engine surge. J Aircraft. 1973; 10(5):274–278.

  • Ikawa H, Laspesa FS. Ignition/duct overpressure induced by space shuttle solid rocket motor ignition. J Spacecraft Rockets. 1985 Jul–Aug; 22(4):481–488.

  • Walsh EJ, Hart PM. Flight-measured lift-off-ignition overpressure-a correlation with subscale model tests. J Spacecraft Rockets. 19(6).

  • Canabal F, Frendi A. Study of the ignition overpressure suppression technique by water addition. J Spacecraft Rockets. 2006 Jul–Aug; 43(4):853–865.

  • Canabal F, Frendi A. On the suppression of ignition overpressure generated by launch vehicles. 9th AIAA/CEAS Aeroacoustics Conference and Exhibit; 2003 May; Hilton Head South Carolina.

  • Simon ED. Titan III ignition overpressure attenuation. AIAA/SAE/ASME 19th Joint Propulsion Conference; 1983 Jun; Seattle Washington.

  • Colombier R, Pollet M. Solid rocket motor ignition overpressure prediction. 27th Joint Propulsion Conference; 1991 Jun; Sacramento CA.

  • Troclet B, Jeanjean S, Alestra S, Terrasse I, Identification of overpressure sources at launch vehicle lift-off using an inverse method. AIAA Modeling and Simulation Technologies Conference and Exhibit; 2003 Aug; Austin Texas.

  • Troyes J, Vuillot F. Numerical simulations of model solid rocket motor ignition overpressure waves. 44th AIAA/ASME/SAE/ASEE Joint Propulsion Conference & Exhibit; 2008 Jul; Hartford CT.

  • Buell JC. Three–dimensional simulation of sts ignition overpressure. AlAA 17th Fluid Dynamics, Plasma Dynamics and Lasers Conference; 1984 Jun; Snowmass, Colorado.

  • Troyes J, Vuillot F, Varnier J, Malbequi P. Numerical simulations of rocket solid motor engine ignition and duct overpressure waves at reduced scale. 45th AIAA/ASME/SAE/ASEE Joint Propulsion Conference & Exhibit; 2009 Aug; Denver, Colorado.


Abstract Views: 333

PDF Views: 0




  • Investigation on the Ignition Over Pressure Related to Launch Vehicle Lift-off

Abstract Views: 333  |  PDF Views: 0

Authors

R. Venkatraman
Satish Dhawan Space Centre, Sriharikota-524124, India
S. Sankaran
Satish Dhawan Space Centre, Sriharikota-524124, India
S. V. Subba Rao
Satish Dhawan Space Centre, Sriharikota-524124, India
P. Krishnaiah
Sri Venkateswara Univeristy, Tirupathi, India
T. Sundararajan
Department of Mechanical Engineering, IIT Madras, India

Abstract


Several transient events occur during the startup of the Solid Rocket Motor (SRM) during the launch vehicle lift-off. Each event produces a complex transient signal and requires systematic assessment. The event discussed in this paper is Ignition Over Pressure (IOP). This Ignition Over Pressure is resulting from fluid dynamic compression of the accelerating plume gas, subsequent rarefaction and propagation during the pressure rise rate period in the rocket combustion chamber. These high-amplitude unsteady fluid-dynamic perturbations can adversely affect the vehicle and its surrounding structure. This wave behaves as a blast or shock wave characterized by a positive triangular shaped first pulse and negative half sine wave second pulse. The pulse travels upwards towards the propulsion system and has the potential to overload the individual elements or exciting overall vehicle dynamics. The later effect results from the phase difference of the wave from one side of the vehicle to the other due to the skew in the ignition of the strap-on boosters. In the case of the launchers, the mechanical stress due to the ignition over pressure wave comes, in addition to the acoustic constraint due to the jet noise. The over pressure phasing or ΔP environment, because of its spectral content as well as amplitudes becomes a crucial input for the design of sub-assemblies viz., thermal shields, and pay loads etc. In this paper, an attempt is made to numerically visualize the propagation of the blast wave causing the unsteady pressure oscillations during the transient pressure rise in the combustion chamber. To understand further, pressure measurements have been made at different heights along the umbilical tower during the solid rocket motor lift-off with the presence of jet deflectors, in order to capture the shock propagation phenomena. From the results, it appears that a sudden shock front that is generated during flow development within the rocket nozzle leaves a clear signature in the form of a well defined peak at typical time intervals. This overpressure amplitude seems to be related to the slope of the combustion chamber pressure rise rate during the transient period. It is also observed that the shock front initially propagates at supersonic speed but decays with time later. Similarly, the magnitude of the IOP peaks are also seen to decay with distance.

Keywords


Ignition Over Pressure, Shock Wave Propagation, Ignition Transient, Solid Rocket Motor, Numerical Flow Visualization

References





DOI: https://doi.org/10.17485/ijst%2F2014%2Fv7i1%2F46810