ARAI Journal of Mobility Technology

Open Access Open Access  Restricted Access Subscription Access
Open Access Open Access Open Access  Restricted Access Restricted Access Subscription Access

Impact of PGM Loading in DOC for Off Road Engine to Meet CEVIV Norms


Affiliations
1 VE Commercial Vehicle Ltd., 102, Industrial Area No.1, Pithampur - 454775 Dist. Dhaz (M.P.), India
     

   Subscribe/Renew Journal


Experimental study was done for evaluation of different type of PGM loading in Diesel oxidation catalyst (DOC) for off road vehicle. The main purpose of DOC is to reduce the hydrocarbon and carbon monoxide from exhaust line and increasing the DOC outlet temperature, which used in soot oxidation in DPF and increased conversion efficiency of SCR. It is very challenging to meet the emission norm with minimum loading of DOC for low cost and durable approach for non-auto application. Test results highlights impact on emission with different PGM loading in DOC.

This paper focused on the calibration of DOC model with different loading and observed that behaviour on THC and CO in exhaust system. Minimum Temperature constraint was come in NRTC rather than NRSC. With low, exhaust gas temperature white smoke observed, when unburned HCs was adsorbed on DOC. Data taken to understand thermal effect on DOC with different loading in aged condition. It observed that maximum DOC loading, conversion efficiency went up to 98% in THC after heating up. DOC loading is also responsible for conversion of NO to NO2, which is used in conversion of SCR efficiency. Detailed comparison and analysis was done to understand the impact of PGM loading in DOC for NO2 formation, exotherm, HC & CO light off temperature behaviour.


Keywords

Diesel Oxidation Catalyst (DOC), Off Road Vehicle, CEVIV Norms, Emission, NO2/NOx, PGMGM.
Subscription Login to verify subscription
User
Notifications
Font Size

  • Chang H. Kim, The Effect of Pt-Pd Ratio on Oxidation Catalysts under Simulated Diesel Exhaust, 2011-01-1164; Published 04/12/2011

  • Irani, K., Epling, W., and Blint, R., “Effect of Hydrocarbon Species on NO Oxidation over Diesel Oxidation Catalysts,” Applied Catalysis B Environment- 92(6-4): 422-428, 2009.

  • Kim, C., Qi, G., Dahlberg, K., and Li, W“Strontium Doped Perovskites Rival Platinum Catalysts for trea-Ting. NOx in Simulated Diesel Exhaust Science, 624-1627, 2010.

  • Després, J., Elsener, M., Koebel, M., Kröcher Schnyder, B. and Wokaun, A. “Catalytic Oxidation of Nitrogen Monoxide Over Pt/SiO2,” Applied Catalysis B Environmental 50(2): 76-82, 2004

  • Allansson R., Blakeman P., Cooper B., Hess H., Silcock P., and Walker A., “Optimizing the Low Temperature Performance and Regeneration Efficiency of the Continuously Regenerating Diesel Particulate Filter (CR-DPF) System” SAE 2002-01-0428

  • Katare, Santhoji R., Joseph E. Patterson, and Paul M. Laing. "Diesel aftertreatment modeling: A systems approach to NO x control."Industrial & engineering chemistry research 46.8 (2007): 244-245.

  • Kim, C., Schmid, M., Schmieg, S., Tan, J. et al. "The Effect of Pt-Pd Ratio on Oxidation Catalysts Under Simulated Diesel Exhaust," SAE Technical Paper 2011-01-1134.

  • Gambhir, H., Barman, J., and Patchappalam, K., Experimental Investigation on the Effect of Pilot and post Injection on Engine Performance and Emissions SAE Technical Paper 2018-28-0015, 2018.


Abstract Views: 216

PDF Views: 0




  • Impact of PGM Loading in DOC for Off Road Engine to Meet CEVIV Norms

Abstract Views: 216  |  PDF Views: 0

Authors

Abhijit Sahare
VE Commercial Vehicle Ltd., 102, Industrial Area No.1, Pithampur - 454775 Dist. Dhaz (M.P.), India

Abstract


Experimental study was done for evaluation of different type of PGM loading in Diesel oxidation catalyst (DOC) for off road vehicle. The main purpose of DOC is to reduce the hydrocarbon and carbon monoxide from exhaust line and increasing the DOC outlet temperature, which used in soot oxidation in DPF and increased conversion efficiency of SCR. It is very challenging to meet the emission norm with minimum loading of DOC for low cost and durable approach for non-auto application. Test results highlights impact on emission with different PGM loading in DOC.

This paper focused on the calibration of DOC model with different loading and observed that behaviour on THC and CO in exhaust system. Minimum Temperature constraint was come in NRTC rather than NRSC. With low, exhaust gas temperature white smoke observed, when unburned HCs was adsorbed on DOC. Data taken to understand thermal effect on DOC with different loading in aged condition. It observed that maximum DOC loading, conversion efficiency went up to 98% in THC after heating up. DOC loading is also responsible for conversion of NO to NO2, which is used in conversion of SCR efficiency. Detailed comparison and analysis was done to understand the impact of PGM loading in DOC for NO2 formation, exotherm, HC & CO light off temperature behaviour.


Keywords


Diesel Oxidation Catalyst (DOC), Off Road Vehicle, CEVIV Norms, Emission, NO2/NOx, PGMGM.

References